ceoloha.blogg.se - Tricks for removing toilet tank bolts

Remove broken or corroded sections of the flange.

Flange selection depends on the type and size of pipe it is being connected to, as well as other application-specific variables.įollow these steps to properly repair your flange using a flange repair ring*: If the drain section of the flange is damaged, a licensed plumber will be needed to completely replace the old flange. Scrape the caulk off the toilet bowl and finished flooring.įirst, inspect the toilet flange for any cracks or decay.

Scrape the old wax seal off the base of the toilet and toilet flange using a putty knife.

Grab the toilet under the sides of the bowl and rock it gently back and forth to break the old wax seal and lift the toilet off the floor.

If the bolt spins as you turn the nut, you will have to grasp the bolt with a separate pair of pliers while removing the nuts.

Remove nuts and washers from the bolts at the toilet base using an adjustable wrench.

Be careful not to apply to much pressure on the porcelain because it may chip or crack. This can be done by inserting a flat head screwdriver under the edge of cap and gentle prying upwards.

Remove the caps that cover the bolts and washers.

Place protective covering on the bathroom floor or bathtub, depending on where you will be placing the toilet while repairing the flange.

If your toilet is caulked to the finished floor of the bathroom, score the caulking all the way around the toilet base with a razor knife.

You should always consider replacing the toilet supply when replacing the wax seal. This will help when resetting the toilet after the wax seal (also called toilet wax ring) is replaced.

Disconnect the water supply line from the toilet fill valve and the 3/8” compression nut.The gel will dissolve when additional water is added.

Use a water absorber, like LiquiLock, to temporarily solidify the remaining water, turning it into a gel, which will help prevent drips and leaks when removing the toilet fixture.Hold the toilet handle down so as much water as possible drains from the tank and the bowl. Remove the lid of the toilet tank and flush the toilet.If a valve is not present, you will need to find another valve located in the basement or crawl space area of the home. The water supply valve should be located behind the toilet just to the left. First, turn off the water supply to the toilet by turning the valve in a clockwise direction.There is a variety of toilet flanges to choose from on the market today, such as PVC, ABS, cast iron, copper and stainless steel, depending on your particular application needs. It also mounts a toilet securely to the finished floor. The good news? With the proper tools, a little know-how and a trip to the local hardware store, most people can effectively repair their own toilet flanges without breaking a sweat (or the bank!) Toilet Flange OverviewĪ toilet flange is a pipe fitting that connects a toilet to the home’s drainage system. The constant rocking will likely break the wax seal (located between the toilet and the flange), allowing water to leak onto the substrate and the ceiling below when the toilet is flushed. Although rather common, a damaged toilet flange must be repaired as soon as possible to prevent leaks that could cause serious damage to your flooring or tile.Ī broken flange will cause the toilet to move because it is no longer secured to the flange, which is anchored to the subfloor. Chances are your toilet flange (also called closet flange) is broken or deteriorating because it wasn’t installed properly. So, your toilet is rocking, and you’ve tried tightening the toilet to floor bolts, but you still can’t seem to get the toilet secured.